THE ULTRA SQUARE

• THE ULTRA SQUARE IS MIRRORED FOR LEFT OR RIGHT HANDED USE. WITH A TAPE ATTACHED YOU MAY MEASURE ANY DISTANCE FROM A BOARD'S END AND MARK PERPENDICULAR AT THE SAME TIME!!
  Measure, center, mark studs and finish two plates in one pass!
  Cut Hip, Valley and Jack rafters right the first time - every time!
  Tape measure clips to GUIDE (for plate layout)!

PLATE LAYOUT SQUARE: LAYOUT PLATES IN 1/2 THE TIME!!
RAFTER SQUARE: AUTOMATICALLY MAKES THE CALCULATIONS!!
FRAMERS SQUARE: MARK BIRDSMOUTH - AND MORE!!
ALSO: A TRY SQUARE, PROTRACTOR AND SAW GUIDE.

The ULTRA SQUARE Automatically Locates The Final Cut Line For Hip, Valley and Jack Rafters at Any Pitch For A Standard 45º Rafter Cut!
The ULTRA SQUARE Automatically Centers Studs, Marks 45º Miters at Any Pitch, Makes Rafter's Ridge Board Deductions, and Locates Hip, Valley and Jack Rafter Measure Point!
The ULTRA SQUARE Marks 2X4 Channel and is 3 Studs Wide.

Hot Links

Other Links: To Ultra Square and Building Sights

Made in the USA
Applied Concepts Engineering; P.O. Box 213; Williams, OR 97544
For more info, Email Ultra-Square